Home
firewall

firewall

Upgrade ASA an Active/Standby Failover Pair Using the CLI

By JMCristobal
August 20, 2022
Security
In this tutorial, we will update two ASA firewall 5585-X from CLI. Actual version 9.8.4.20Target version 9.8.4.44 Note: Perform these steps on the active unit Step 1 – ...
Read more 0

Configure SNMP on ASA Firewall

By JMCristobal
March 9, 2022
Security
SNMPv2 Specify the recipient of an SNMP notification, indicate the interface from which traps are sent, and identify the name and IP address of the NMS or SNMP ...
Read more 0

Configuring OSPFv2 on ASA Firewall

By JMCristobal
October 15, 2021
Security
Create an OSPF routing process: asa-jmcristobal(config)# router ospf process_id Define the IP addresses on which OSPF runs and the area ID for that interface: asa-jmcristobal(config)# network ip_address mask ...
Read more 0

Configure EIGRP on the ASA Firewall

By JMCristobal
October 8, 2021
Security
Create an EIGRP routing process asa-jmcristobal(config)# router eigrp as-num Configure the interfaces and networks that participate in EIGRP routing: asa-jmcristobal(config-router)# network ip-addr [mask] We can configure one or ...
Read more 0

Configure Default and Static Routes – ASA Firewall

By JMCristobal
September 30, 2021
Security
Configure a Default Route A default route is simply a static route with 0.0.0.0/0 as the destination IP address. ASA would be configured using the command route {nameif}. ...
Read more 0

Cisco ASA Remote Management – SSH/ASDM

By JMCristobal
August 10, 2021
Security
By default SSH, telnet or https management is disabled. First of all we must have configured the management interface of the equipment, something similar to: ASA-JMCristobal# sh run ...
Read more 0

About this Website

This website is free and educational. Contains my thoughts and ideas, which may not represent the thoughts of the various technologies mentioned here. All product names, logos, and illustrations are copyright/trademarks of their respective owners.
en_US
es_ES en_US